The PR 35 mic achieves its exceptional performance by using a special magnet structure and a large aluminum 1-1/2″ low-mass voice coil assembly. A carefully wound and placed hum bucking coil allows the Heil PR 35 to be placed near video monitors without unwanted hum or buzz. Special attention has been paid to the phasing plug assembly with equally placed ports that sense audio from behind the source. It then enters them out of phase, thus producing a very linear cardioid pattern. This reduces the proximity effect while achieving the extreme articulation across its smooth 40 Hz – 18 kHz frequency response. The Heil element can be used in extreme high sound pressure levels and is immune to overload conditions. It produces a beautifully smooth audio response without the inconvenience of phantom or outside DC powering.
The PR 35 microphone is equipped with a low-cut roll-off switch to prevent low-end feedback loops from ever getting started.
The Heil PR 35 mic’s cardioid pattern offers the greatest rejection of unwanted audio at 180 off axis, which is directly behind the microphone; there is virtually no off-axis coloration.
Supplied with a microphone clip that mounts to any 5/8″ 27-thread mic stand. It also comes with a leatherette carrying case and wind screen.
For amateur radio, a CC-1 XLR cable is required to interface with a transceiver.
- 7-2/3″ long x 2″ wide at mic vocal end and 1″ wide at XLR-input end Largest dynamic element in a hand held microphone
- Wide frequency response
- Articulate natural mid range
- 2-position roll-off switch
- Rubberized coating





















Reviews
There are no reviews yet.